In This Article: When to Fertilize How to Measure Growth Choosing Your Fertilizer How Much Fertilizer to Use Applying the Fertilizer
Fruit trees need good nutrition to grow and produce an abundant harvest, just like vegetables, flowers, and other plants. In our helpful video, Tricia explains if, when, and how much to fertilize your fruit trees. Or keep reading here to learn the 5 Easy Steps for fertilizing your fruit trees!
Step 1: When to Fertilize Your Fruit Trees
Fruit trees give us a rewarding crop in the summer and fall, but they need to be fed. The best time to fertilize is in the spring, just before bud break. You can feed throughout the summer but it is best to stop applying any nitrogen after July.
Step 2: Measure to Decide if You Need to Fertilize
Not all fruit trees need to be fed every year nor in the same amounts. If you feed them too much nitrogen they will grow lots of leaves but give you very little fruit. Luckily the fruit tree can tell you what it needs, just do a little measuring.
Steps in Measuring the Previous Year's Growth
- First–locate last year’s growth rings. The growth ring is the point on the branch where the fruit tree started growing in the previous season. The newest growth that you will be measuring is often a different color than the rest of the branch.
- Second–measure from the growth ring all the way out to the end of the branch. Repeat these measurements at several spots around the fruit tree.
- Third–calculate the average of these measurements. This is the previous season’s “annual growth” of the fruit tree.
Repeat this step for each of your fruit trees. Even if you have several fruit trees of the same variety and age, they may not have grown at the same rate and thus have different fertilizer needs. Note–if you have pruned your fruit tree significantly more than normal, so that you’ve removed over 20% of its canopy within the last year, don’t fertilize until the next year.
Check the Chart to Evaluate Growth
Finally, use this chart to evaluate your fruit tree’s annual growth. If the fruit tree’s growth rate is at the low end of, or below, annual target growth, then you should fertilize the fruit tree this year. If your fruit tree’s growth rate is at the high end of, or above, the annual target growth rate, you do not need to fertilize this year (but measure again next year in case that changes!).
- Peaches and nectarines–non-bearing young fruit trees should grow 18"-24", mature bearing trees should grow 12"-18".
- Apples and pears–non-bearing young fruit trees should grow 18"-30", mature bearing pears and non-spur type apples should grow 12"-18".
- Bearing spur apples should grow 6"-10".
- Plums and sweet cherries–non-bearing young fruit trees should grow 22"-36", mature bearing trees should grow 8".
- Tart cherries–non-bearing young fruit trees should grow 12"-24", bearing mature trees should grow 8".
Step Three: Choose the Right Fertilizer
- Fruit trees prefer an organic, high nitrogen fertilizer.
- Blood meal, soybean meal, composted chicken manure, cottonseed meal, and feather meal are all good, organic nitrogen sources.
- There are also specially formulated fruit tree fertilizers.
- In addition to nitrogen, your fruit tree needs other macro and micronutrients too. Adding compost when you fertilize is a good way to provide organic matter and trace minerals. Azomite or Cascade Remineralizing Soil Boost are good sources of trace minerals.
A soil test can tell you whether you need to add more phosphorus, potassium and other nutrients.
Step Four: Calculate how Much Fertilizer to Use
More is not always better when it comes to fertilizing your fruit trees. Now that you know that your fruit tree needs fertilizer, and have picked the perfect fertilizer to use, you’ll need to determine the correct amount to use on each fruit tree.
For those of us who did not excel in math—fear not—we will walk you through the fertilizer calculations.
The amount of fertilizer you will use is calculated based on the age or size of the fruit tree, and the nitrogen-value on the package.
Determining How Much Fertilizer to Use
- Fruit trees need 0.10 pounds of “actual nitrogen” per year of age, or per inch of trunk diameter (measured 1 foot above the ground). The maximum you should give a fruit tree in a year is 1 pound of actual nitrogen.
- For example, if your fruit tree has a diameter of 5 inches (or, if your tree is 5 years old), multiply 5 by 0.10 pounds of nitrogen, equals 0.5 lb. This means that the fruit tree will need 0.5 lb of actual nitrogen.
- But wait, you’re not done yet! “Actual nitrogen” pounds is not the as simple as just weighing out that amount of fertilizer, because there is more in a fertilizer than just nitrogen.
- The NPK numbers on fertilizer show the percentage of nutrients per pound of fertilizer, not the actual amount. N, P and K refer to nitrogen, phosphorus, and potassium.
- For example, if the N listed on the fertilizer package is 7 (meaning 7% nitrogen), such as with E.B. Stone’s Fruit Tree fertilizer, then there is 0.07 pounds of actual nitrogen for every pound of fertilizer.
- To calculate how much fertilizer to apply, divide the amount of actual nitrogen the fruit tree needs by the amount of actual nitrogen per pound in the fertilizer.
- So, using the previous examples, a five-year-old apple tree needs 0.5 lb of nitrogen. The E.B. Stone Fruit Tree Fertilizer has an N-value of 7 on the package, meaning it has 0.07 lb nitrogen per pound of fertilizer. Half a pound, or 0.5 lb, divided by 0.07 lb equals 7 lbs. The answer–7 pounds–is the amount of this fertilizer to apply to the fruit tree.
Step Five: Applying the Fertilizer
To help the fruit tree “eat” the fertilizer most efficiently, apply the fertilizer evenly starting a foot away from the trunk and continue all the way to the “drip line.” The drip line is the perimeter of the tree’s furthest reaching branches.
- The easiest way to do this is simply by spreading the fertilizer on the ground and raking it in.
- Digging a series of small holes is another method of applying fertilizer. It is a bit more work, but it best ensures the fertilizer is getting to the fruit tree roots, especially when using a fertilizer containing less-soluble nutrients like phosphorus and mycorrhizae.
- Dig the holes six inches down and 12” to 18” apart, throughout the same area as you would have spread the fertilizer. To make the digging job easy you can use an auger attachment with a cordless drill. Sprinkle a little bit of fertilizer in each hole until it is used up.
- Once you have finished fertilizing, spread an inch-deep layer of compost around the fruit tree and water well.
For more information on all aspects of fruit trees—selecting and planting a bare root, pruning, controlling pests, and even how to preserve your harvest—browse our videos and articles in Fruit Tree Central. Some staff-favorite books on fruit trees are The Home Orchard from UC Davis, along with The Fruit Gardener's Bible.
Keep on living the dream with your organic orchard, now that you know when and how to fertilize your fruit trees.
Steve, You can fertilize in September with a fertilizer that does not have any nitrogen in it. You do not want to put a bunch of nitrogen on your trees in the fall, since you do not want to stimulate growth before fall. The new growth could be damaged by cold weather. If you wanted to put on some soft rock phosphate, or our foothill fertilizer mix without nitrogen, then that would be ok.
Some of our neighbors fertilize their fruit trees in September. Is that a good idea?
Mary, I am not an expert on tropical fruit trees but sounds like you do not have enough phosphorus to support your tree. But rather than blindly fertilize, you might consider getting a soil test done to see where your soil’s nutrition is at. Might be low on other nutrients in addition to the phosphorus.
I have a guava tree for 7 years but it keeps blooming and then it all falls off, what should I do?
Ni, the tree planting kits can be very helpful, especially the fertilizer that is in the kit. The fertilizer is formulated for bare root trees and plants. You can amend your soils, especially important if you have heavy soil or poor drainage. You can put the spiral tree guard on after you plant the tree. We have lots of information on our website. Here is an article on summer cover crops, https://www.groworganic.com/blogs/articles/grow-cover-crops-in-the-summer?pos=1&psq=summer%20cover%20c&ss=e&v=1.0