Drip Tape Loc Sleeve 1/4" Barbed Fitting

The fitting you need to take drip tape runs off 1/2" poly tubing at a 90 degree angle. Loc Sleeve end inserts into drip tape and is secured by twisting the lock over the end of the tape. The small barbed end punches into the side of the poly tubing.

Drip tape must be used on low pressure (5-15 psi), achieved by installing a pressure regulator. Drip tape needs to be on flat runs (no greater than 3% if sloped) and no longer than single runs of 450 feet. The more level the ground and the shorter the run, the more even and uniform the water flow.

Warning: This product or its packaging contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information see www.p65warnings.ca.gov.