1/2" Soaker Hose - (50' Roll)

This high-quality soaker hose releases water along its entire length for low-flow irrigation. It is UV-stabilized for above- or below-ground installation and is made from 100% recycled materials. Soaker hose can be used in gardens, orchards, perennial borders, flower beds, planters and raised beds. Can also be used around building foundations (1-2 feet from edge of foundation) to keep soils from drying out in summer.

• ID is 0.590", OD is 0.820", Wall thickness is 0.115"
• Installation spacing depends on your soil texture, but a general guideline is 18" apart, with maximum run of 250'.
• Flow rate is approximately 54 gal/hr per 100' of hose at 10 PSI, or approximately 224 GPH per 100' of hose at 25 PSI.
• Burst strength is 80 psi. Do not run on city water without a pressure regulator.
• It is recommended that you use a 22-25 PSI regulator for ideal performance.
• Maximum run for professional grade soaker hose is 250' per length with a maximum of 500' per faucet (water source) at one time.

This is bulk hose with NO fittings on the hose, they must be purchased separately. Soaker hose is a low flow, low pressure system used by both home gardeners and professionals. As a guideline, turn faucet a 1/2 turn, if your hose sprays and doesn't weep you have too much pressure, so turn down the faucet.

For best results, bury the hose at least 4" deep. Soaker hose needs low water pressure and requires a regulator. Soaker hose also requires a filter (at least 150 mesh) to screen out small particles. If your water has heavy mineral deposits, Soaker hose is not recommended. If mineral deposits are a concern, review available irrigation filters and confirm suitability for your water source. For use on a well system, a filter is required so that particles that might clog the pores of the tubing will be filtered out. Well water typically has particles of sediment in suspension.

Soaker hose is not recommended for hilly terrain. Should be used on flat surfaces not exceeding a 2' rise over 100'. It is not designed for tight turns. The hose can kink and then will break apart at that point. Soaker hose can be used in straight lines or snaked back and forth between plants. Barbed fittings fit inside soaker hose and metal clamps are needed to secure the fittings.

Shop compatible soaker hose and fittings, and use our drip irrigation resources for planning and installation help.